38
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
Now LOWER THE TWO REAR ROLLERS.
First fi t the leveling tool on the hexagonal
adjusting nut as shown below.
Make 10 complete (360°) turns clockwise. (This
means turning and removing the leveling tool 20
times).
Make sure you lower BOTH REAR ROLLERS.
There are two adjusting nuts, one for each roller,
at both the front bottom corners of the range.
Note the rollers are only intended to aid
installation - the range should not be
moved once it is installed.
Push the range close to its fi nal position, leaving
just enough space to get behind it.
Do not refi t the storage drawer yet
IMPORTANT!
Remove all tape and packaging. Make sure the
burners are properly seated and level. Take the
accessory pack out of the oven. Check to be
sure that no range parts have come loose during
shipping.
To Next Page
Loading...
Need help?
General
