AGA Mercury User Manual

INSTALLATION
Check the appliance is electrically safe when you have nished.
20
Regulations
n
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest
edition.
n
In Canada, installation must conform with the
current Natural Gas Installation Code, CAN/
CGA-B149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local codes where
applicable.
n
The range must be electrically grounded in
accordance with local codes or, in the absence
of local codes, in accordance with the National
Electrical Code (NFPA 70, latest edition). In Canada,
electrical grounding must be in accordance with the
current CSA C22.1 Canadian Electrical Code Part 1
and/or local codes. See ‘Electrical Connection’ in this
section.
This range has been tested and approved according to ANSI
Z21.1. CSA 1.1, latest edition and CAN/CGA-22.2 latest edition.
Read the instructions before installing or using this appliance.
This range becomes hot in use, the cooktop burners produce
exhaust gases.
Important
n
Observe all governing codes and ordinances.
n
The range must be properly grounded.
This appliance is heavy. Ensure you have the correct
facilities to complete the move.
n
Ensure all clearances are followed. Refer to
positioning the range.
n
Save these instructions for the local electrical
inspector’s use.
For Your Safety
DO NOT store or use combustible materials, gasoline or other
ammable vapors and liquids in the vicinity of this or any
other appliance.
If You Smell Gas
• Open windows.
• DO NOT touch electrical switches.
• Extinguish any open flame.
• Immediately call your gas supplier.
Installation Safety Instructions
n
Improper installation, adjustment, alteration,
service or maintenance can cause injury or property
damage. Refer to this manual. For assistance or
additional information, consult a qualied service
engineer.
n
Never reuse old exible connectors. The use of old
exible connectors can cause gas leaks and personal
injury. Always use NEW exible connectors when
installing a gas appliance.
Important!
• Remove all packing material and literature from oven
before connecting gas and electrical supply to range.
• Have your range installed by a qualified installer.
• Your range must be electrically grounded in accordance
with local codes or, in the absence of local codes, in
accordance with the National Electrical Code (NFPA 70,
latest edition).
• DO NOT install your range on a substrate that cannot
withstand 180 °F (82 °C).
• DO NOT install your range directly onto carpeting.
Ensure an appropriate, non-combustible, substrate is
installed prior to installing the range.
• Make sure the wall coverings around the range can
withstand heat generated by the range up to 200 °F
(93 °C).
• Avoid placing cabinets above the range. There must be
a gap of at least 30’’ (762 mm) between the top of the
range and any combustible surface above it.
• If a ventilating hood is installed above the range follow
the installation instructions supplied with the hood.
n
Items of interest to children should not be stored
above a range – children climbing on the range to
reach items could be seriously injured.
Converting to Propane Gas
This appliance is supplied set for Natural gas.
A conversion kit for Propane gas is supplied with the range.
If the appliance is to be converted this must be done before
installation. The conversion must be performed by a qualied
LP gas installer. See the ‘Conversion’ section at the back of this
installation manual for more details.
n
For installation 5000 ft above sea level the appliance
must be converted using high altitude kit A065744.
Contact your distributor.
8. Installation Safety Instructions

AGA Mercury Specifications

General

Brand	AGA
Model	Mercury
Category	Ranges
Language	English