4
How To Use The LT300
Setup
Horizontal
The laser can be used on a 5/8-11 tripod, on a wall mount, or directly on a
solid, stable surface.
Vertical
The laser can be placed directly on a solid, stable surface.
Place the laser on the side with the two adjustable feet (6). Rough level the
laser by using the feet to center the bubble in the vertical vial (4).
The LT300 has a wide self-leveling range; however, if the laser is set up out
of the leveling range, laser beam will continue to blink and rotation will not
start.
Turning On the Laser
Turn on the laser with the On / Off key (5). It does a self-test and the beam
blinks while the laser is self-leveling. After it’s leveled, the head rotates.
Automatic/Manual Mode
The laser is in automatic self-leveling mode when turned on.
To put in manual mode, press (2) on the laser keypad. The LED indicator (8)
located near the Auto/Man key will blink to remind you that the laser is in
manual mode.
Yo
u cannot use H.I. Alert in Manual Mode.
CAUTION: In manual mode, the beam rotates even if the laser is not leveled.
To Next Page
Loading...
