13
2313B EN 20041109
Introducing the CR User Station
CR USER STATION
• Make sure that the two safety caps are mounted on top of the right side
rollers in case of a stand-alone CR User Station (this means that the
CR User Station is not connected to a CR 25.0 Digitizer), as shown below:
Safety precautions for the monitor
• The monitor must be fixed on the monitor arm with screws.
• If the monitor arm is re-positioned in a different height the lock must be
closed.
Safety instructions for cleaning the
CR User Station
• Pull the power plug out of the CR User Station prior to cleaning the
equipment and switch off the UPS (Uninterruptible Power Supply) if
installed.
To Next Page
Loading...
