AGFA SnapScan 300 - S E T T in G T H E Scan N E R T O a S CS I ID N U Mb E

Chapter 2 — Installing the scanner for the Macintosh computer 17
4. Check in the SCSI ID table if SCSI ID number 2 is free.
If SCSI ID number 2 is already assigned, you need to set the scanner to a free
SCSI ID number. (see Setting the scanner to a SCSI ID number )
5. Click OK to close the SCSI ID Checker.
Setting the scanner to a SCSI ID number
1. Make sure your scanner is switched off and is disconnected from your
computer.
2. Choose an unassigned SCSI ID number.
3. Push the button above or underneath the SCSI ID number at the rear of the
scanner until you see the number you want.
All manuals and user guides at all-guides.com