Operation 2
3200P pH Meter User Guide 41
Storing Data
The meter can save up to 200 sets of pH data. When the
meter saves data depends on the measuring mode. In
Continuous Mode and Auto-Lock Mode, press [Save] to save data
when the readings become stable. In Timed Reading mode, the
meter will automatically save measurement data after the
measurement time expires. (Data can always be saved
manually.)
To delete saved data
The meter can both save and delete data. Inaccurate or
unwanted data can be deleted individually or all at once.
1 From the initial or measuring mode, press [View] to
display data.
2 Scroll to the data to delete, then press [Delete].
To output data
There are two ways to output current measurements,
calibration data or saved data. One method is to use
optional G4390A the data collecting software with the meter.
The other method is to use the free Data Printing Software.
1 Connect the meter to the PC with a USB cable, and run
the software.
2 Press the [Output] key during measurement, while viewing
calibration or stored data. This allows the user to print
the corresponding data. Refer to the software operating
instructions for details.
See “Installing the Electrochemical Data Collecting
Software” on page 10.
To Next Page
Loading...
Need help?
General
