43
Chapter 2 Front-Panel Menu Operation
Front-Panel Menu Reference
4
2
Front-Panel Menu Reference
This section gives an overview of the front-panel menus. The remainder
of this chapter contains examples of using the front-panel menus.
Select a waveform
• Select one of nine waveform types, including Sine, Square, Ramp, Pulse,
Arbitrary, Triangle, Noise, PRBS, and DC.
Configure parameters for the selected waveform
Depending on the waveform, you can do some of the various tasks:
• Configure Period/Frequency
• Configure Amplitude
• Configure Offset
• Configure Phase
• Configure Duty Cycle
• Configure Symmetry
• Configure Pulse Width
• Configure Edge Times
• Configure Arbitrary Waveforms
• Configure Bandwidth
• Configure PRBS Data
• Configure Bit Rate
Specify what units and parameters to use for various waveforms.
• Specify whether to use Frequency or Period
• Specify whether to use Amplitude and Offset or High and Low Voltage
• Specify which voltage units to use
• Specify whether to use Width or Duty Cycle
• Specify whether to configure Frequency sweep as Center/Span or Start/Stop
To Next Page
Loading...
Need help?
General
