Using the Oscilloscope
To recover your Infiniium hard disk
3-70
To recover your Infiniium hard disk
Your Infiniium oscilloscope comes with a set of recovery disks called the User’s
Hard Drive Recovery Disks. You should use these recovery disks to restore
your hard drive in the rare event that something may have destroyed the
Windows operating system or the Infiniium application software.
The Infiniium hard disk recovery system consists of 120 MB (LS-120) floppy
disks containing the Windows operating system and the Infiniium application
software. If you have to use the recovery disks, the Infiniium hard disk is
returned to the condition it was in when it left the factory.
1 Turn off the Infiniium.
2 Put Recovery disk #1 in the floppy drive.
3 Turn on the Infiniium. Infiniium will boot from Recovery disk #1
4 Follow the onscreen instructions.
5 Once the installation is complete, remove the Recovery disk from the
floppy drive.
6 Turn off the Infiniium.
7 Turn on the Infiniium.
The Infiniium application software that you just installed is the version that
originally came with your Infiniium. There may be a newer version of the
Infiniium application software available at our web site that you can download
and install for free. The internet address is:
www.agilent.com/find/infiniium_support
To Next Page
Loading...
Need help?
General
