Site Preparation
Site Preparation Guide 39
Installation and Verification
Installation
Once the installation has begun, it should progress in a timely manner to
completion. Delays due to inadequate site preparation could cause loss of
instrument use during the warranty period. In extreme cases, Agilent
Technologies may ask to be reimbursed for the additional time required to
complete the installation.
The primary user and, if possible, all other users of the MSD should be present
during installation to receive familiarization instruction from the Agilent
Technologies service representative.
Verification
The final step in the installation process is system verification. Your Agilent
Technologies service representative will test the system against Agilent
Technologies specifications as documented for the product(s) or system(s) you
have purchased. (Not all tests are performed for every system.)
The Agilent Technologies service representative will not test your
system against your standards or samples. Further, the Agilent
Technologies service representative will not set up your laboratory
procedures. Assistance with laboratory procedures can be obtained from your
local Agilent Technologies Applications Engineer (AE) on a consulting basis at
additional cost.
5975 Series Site Prep.book Page 39 Thursday, January 31, 2008 9:47 AM
To Next Page
Loading...
Need help?
General
