Getting Started
Step 4. Set up and run an acquisition method
Agilent 6400 Series Triple Quadrupole LC/MS Quick Start Guide 25
You can run a Data Analysis method from this window by selecting
Both Acquisition and DA or DA Only for the Method Type. In
addition, you have to set Override DA method to indicate which Data
Acquisition method contains the DA (Data Analysis) method to execute.
You always have to do this.
d To start the single sample run, click the Run button ( ) in the Sample
Run window or the Run button ( ) in the main toolbar.
You can run the single sample in either locked or unlocked mode. When
the mode is locked, no one can change the method or sample
parameters during a run. You also cannot overwrite this data file in the
Data Acquisition program. The Lock button ( ) in the main toolbar
indicates that locked mode is on.
11 Set up and run worklists
a Click the Worklist tab to show the Worklist window. If the Worklist window
is not visible, click View > Worklist.
b Right-click the upper left corner of the worklist.
c Click Add Multiple Samples. The Add Multiple Samples dialog box opens.
d Enter all the information on the Sample Information tab.
e Click the Sample Position tab to specify the sample vial locations (make
sure the specific sample tray type has been configured by right-clicking the
autosampler device image).
To Next Page
Loading...
Need help?
General
