Introduction to Programming GPIB Interface
16 Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
GPIB Interface
The interface used by your instrument is the GPIB (General Purpose
Interface Bus).
GPIB is the interface used for communication between a controller and an
external device, such as the tunable laser source. The GPIB conforms to
IEEE standard 488-1978, ANSI standard MC 1.1 and IEC recommendation
625-1.
If you are not familiar with the GPIB, then refer to the following books:
• The International Institute of Electrical and Electronics Engineers. IEEE
Standard 488.1-1987, IEEE Standard Digital Interface for Programmable
Instrumentation. New York, NY, 1987
• The International Institute of Electrical and Electronics Engineers. IEEE
Standard 488.2-1987, IEEE Standard Codes, Formats, Protocols and
Common Commands For Use with ANSI/IEEE Std 488.1-1987. New York,
NY, 1987
To obtain a copy of either of these last two documents, write to:
The Institute of Electrical and Electronics Engineers, Inc.
345 East 47th Street
New York, NY 10017
USA.
In addition, the commands not from the IEEE-488.2 standard, are defined
according to the Standard Commands for Programmable Instruments
(SCPI).
For information about SCPI, and SCPI programming techniques, please
refer to:
• The SCPI Consortium: Standard Commands for Programmable
Instruments. To obtain a copy of this manual, contact the following
address:
SCPI Consortium Office
Bode Enterprise
2515 Camino del Rio South, Suite 340
San Diego, CA, 92108
USA
Web: http://www.scpiconsortium.org
To Next Page
Loading...
Need help?
General
