Specific Command Summary Specific Commands
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition 51
[:SOURce[n]][:CHANnel[m]:]WAVelength:SWEep
:CHECkparams? Returns whether sweep parameters set are consistent. page 136
:CYCLes/? Sets or returns the number of cycles. page 137
:DWELl/? Sets or returns the dwell time. page 138
:EXPectedtriggers? Returns number of triggers (used to configure power meter). page 138
:FLAG? Returns whether waiting for trigger, or logging data available. page 139
:LLOGging/? Switches lambda logging on or off or queries the state of lambda
logging.
page 140
:MODE/? Sets or returns the sweep mode. page 141
:PMAX? Returns the highest permissible power for a wavelength sweep. page 141
:REPeat/? Sets or returns the repeat mode. page 142
:SOFTtrigger Sends a soft trigger. page 143
:SPEed/? Sets or returns the speed for continuous sweeping. page 143
:STARt/? Sets or returns the start point of the sweep. page 144
:STOP/? Sets or returns the end point of the sweep. page 144
[:STATe]/? Stops, starts, pauses or continues a wavelength sweep or returns
the the state of a sweep.
page 145
[:SOURce[n]][:CHANnel[m]:]WAVelength:SWEep:STEP
:NEXT Performs the next sweep step. page 146
:PREVious Performs the previous sweep step again. page 146
[:WIDTh]/? Sets or returns the width of the sweep step. page 146
Table 4 Specific Command Summary (continued)
Command Description Page
To Next Page
Loading...
Need help?
General
