614 Chapter14
Analyzer Messages
Interpreting Analyzer Messages
Interpreting Analyzer Messages
The analyzer firmware displays error messages and informational
prompts to warn the user of instrument failure or improper use.
There are three types of messages: hardware-error messages (H),
informational messages (M), and user-created error messages (U).
• Hardware-error messages indicate that the firmware has detected a
fault in the analyzer hardware.
• Informational messages provide prompts or messages to inform the
user of the analyzer status during a specific routine.
• User-created error messages indicate the analyzer is being used
incorrectly. They are usually generated during remote operation.
What's in This Chapter
Each analyzer message is listed in alphabetical order. The following
information is provided, where applicable:
• The message type, identified by an H, M, or U.
• An operational definition for each analyzer message.
• The related analyzer assembly, or assemblies, that is the likely cause
of the problem defined by the hardware-error message.
• Relevant troubleshooting hints.
To Next Page
Loading...
Need help?
General
