To Next Page

To Previous Page

S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Proguide\Chapters\prog_prog_guide_step6.fm

Step 6: Make Measurements

Step 6: Figure 1. Process for Making Measurements

Start set of concurrent

measurements using

INITiate command.

Determine

which measurement

is done using

INITiate:DONE?

query.

INITiate:DONE? query

returns WAIT (no

measurements are done).

INITiate:DONE? query

returns NONE (all

measurements are done).

Stop

Start

INITiate:DONE? query

returns name of

measurement that is done.

Use FETCh? query to

obtain measurement

results.

Table of Contents11
Conventions Used in this Programming Guide14
Purpose of this Programming Guide14
How this Programming Guide Is Organized14
How to Use this Programming Guide16
About the Programming Examples Presented in this Programming Guide16
Step 1: Set the Test Set's Operating Mode to Active Cell17
Background17
Overview of Active Cell Operating Mode17
Setting the Test Set's Operating Mode to Active Cell18
Step 2: Configure the Base Station Emulator (BSE)19
Background19
Configuring the Broadcast Channel Parameters20
Configuring the Traffic Channel Parameters22
Things that Can Go Wrong23
Step 3: Configure the Measurement Execution Parameters24
Background24
Overview25
Configuring Measurement Averaging Parameters26
Configuring Measurement Triggering Parameters27
Configuring the Burst Synchronization Parameter28
Configuring Measurement Timeout Parameters29
Configuring Measurement Specific Parameters30
Step 4: Establish an Active Link with Mobile Station32
Background32
Overview36
Process for Making a Base Station Originated Call36
Process for Making a Mobile Station Originated Call39
Step 5: Set the Mobile Station's Operating Conditions42
Overview42
Step 6: Make Measurements43
Background43
Things that Can Go Wrong46
Step 6A: Start Set of Concurrent Measurements47
Starting Measurements47
Step 6B: Determine if a Measurement Is Done49
Background49
Overview49
Step 6C: Obtain a Set of Measurement Results51
Background51
Overview52
Step 7: Perform an Intra-Cell Handover53
Background53
Performing an Intra-Cell Handover53
Performing a Dual-Band Handover54
Step 8: Disconnect the Mobile Station from the BSE57
Background57
Overview58
Terminating an Active Call from the Base Station Emulator58
Terminating an Active Call from the Mobile Station59
Comprehensive Program Example63
Example Program with Comments64
Example Program Without Comments69

Brand	Agilent Technologies
Model	8960 Series
Category	Test Equipment
Language	English

Agilent Technologies 8960 Series Programming Guide

Table of Contents

Other manuals for Agilent Technologies 8960 Series

Questions and Answers:

Agilent Technologies 8960 Series Specifications

Related product manuals