Unpacking and Installation
28 Agilent Cary 600 Series FTIR Spectrometers and Microscopes User’s Guide
4 If you are sure that all boxes have been delivered and appear to
be undamaged, place them where their contents can come to
room temperature.
CAUTION
Do not unpack any additional boxes or packages or the spectrometer or
microscope unless otherwise instructed by your Agilent representative. Your
Agilent representative will complete the unpacking and installation of your
Agilent Cary 600 Series FTIR spectrometers and microscopes. If incorrectly
unpacked, equipment may become damaged.
Installing the software
While your Agilent representative will install the Resolutions Pro
software for you during the installation process, it may become
necessary to re-install it if the computer is replaced.
The Agilent Resolutions Pro software installation disks will install all
files required to run the software.
See the Agilent Resolutions Pro Software Installation Manual for
instructions on how to install and register your software.
Spectrometer and microscope connections
While your Agilent representative will install the spectrometer and
microscope for you during the installation process, it may become
necessary to reconnect cables if you move the instruments.
Spectrometer
Power is connected to the instrument and purge line (if used) at the
rear of the instrument.
To Next Page
Loading...
Need help?
General