2
General Information
This is the User’s guide for your Agilent E3633A and E3634A DC power
supplies. Unless otherwise stated, the information in this manual applies to
both two models.
This chapter provides a general description of your power supply . This chapter
also contains instructions for initial inspection, location and cooling for bench
and rack operation, selecting the power-line voltage, and connecting your
power supply to ac power.
Safety Considerations
This power supply is a Safety Class I instrument, which means that it has a
protective earth terminal. That terminal must be connected to earth ground
through a power source with a 3-wire ground receptacle.
Before in stallation or operation , check the power supply and review this
manual for safety markings and instructions. Safety information for specific
procedures is located at the appropriate places in this manual. See also
‘‘
Safety
’’ at the beginning of this manual for general safety information.
Safety and EMC Requirements
This power supply is designed to comply with the following safety and EMC
(Electromagnetic Compatibility) requirements:
• IEC 1010-1(1990)/EN 61010-1(1993) + A2 (1995) : Safety Requir ements for
Electrical Equipment fo r Measurem ent, Control, and Laboratory Use
• CSA C22.2 No.1010.1-92: Safety Requirement s for Electrical Equipment for
Measurement, Control, and Laboratory Use
• EN50082-1(1992):
IEC 1000-4-2(1995): Electrostatic Discharge Requirements
IEC 1000-4-3(1995): Radi ated Electrom agnetic Field R equirem ents
IEC 1000-4-4(1995): El ectrical Fast Trans ient/ Bu rst Requi rements
EN 61000-4-5(1995): Surge Requirements
EN 61000-4-6(1995): Conducted Radio Frequency Immunity Requirements
EN 61000-4-8(1993): Magnetic Field Requirements
EN 61000-4-11(1994): Voltage dips, short, interruption and var Requirement
• Low Voltage Directive 73/23/EE C
• EMC Directive 89/336/EEC
To Next Page
Loading...
Need help?
General
