74
Remote Interface Reference
• SCPI Command Summary‚ starting on page 75
• Simplified Programming Overview‚ starting on page 81
• Using the APPLy Command‚ on page 84
• Output Setting and Operation Commands‚ starting on page 85
• Triggering‚ starting on page 91
• System-Related Commands‚ starting on page 94
• State Storage Commands‚ on page 97
• Calibration Commands‚ starting on page 98
• Interface Configuration Commands‚ on page 101
• The SCPI Status Registers‚ starting on page 102
• Status Reporting Commands‚ starting on page 112
• An Introduction to the SCPI Language‚ starting on page 115
• Halting an Output in Progress‚ on page 120
• SCPI Conformance Information‚ starting on page 121
• IEEE-488 Conformance Information‚ on page 124
If you are a first-time user of the SCPI language, you may want to refer to these
sections to become familiar with the language before attempting to program the power
supply.
SCPI
SCPI
SCPI
To Next Page
Loading...
Need help?
General
