ESG Family Signal Generators Hardkey and Softkey Reference
Sweep/List
User’s Guide 4-107
Sweep Trigger
Reveals a menu of choices for triggering a full sweep. You can choose
triggering that occurs immediately once a sweep is armed, triggering
that is supplied by the GPIB, triggering on either the positive or
negative edge of a signal supplied to the TRIGGER IN connector, or
triggering by the front panel
Trigger key.
Default Value: Immediate
Softkey Location:
Sweep/List > Sweep Trigger
Sweep Type List Step
Toggles the sweep type from list sweep to step sweep. You create a list
sweep by supplying the frequency, amplitude, and dwell time for each
point in the sweep. You create a step sweep by supplying the start and
stop frequency and amplitude, the number of points, and a dwell time.
The signal generator then calculates the points between the first and
last point in a linear manner.
Default Value: List
Softkey Location:
Sweep/List > Sweep Type List Step
Trigger Key
This softkey is one of the choices in both the Sweep Trigger menu and
the Point Trigger menu. Press either the
Sweep Trigger softkey or the
Point Trigger softkey to view these menus. Choosing Trigger Key in the
Sweep Trigger menu immediately triggers an armed sweep when you
press the
Trigger front panel key. Choosing Trigger Key in the Point
Trigger menu immediately triggers the next point in a running sweep.
Softkey Location:
Sweep/List > Sweep Trigger > Trigger Key
Or: Sweep/List > Point Trigger > Trigger Key
To Next Page
Loading...
