Chapter 4
Front-Panel Key and SCPI Command Reference
Front-Panel Keys
138
Front-Panel Key and SCPI Command
Reference
4.2.3.4 Clear Power Sensor
Clear all the information, including the cal factors, of the Power Sensor.
4.2.3.5 Delete All Points
Deletes all points.
4.2.3.6 Edit Cal Factors
Accesses the editor that is used to show and edit the power sensor calibration factors.
4.2.3.6.1 Cal Factor
Sets the calibration factor of the current point.
Mode: MRECEIVE
Key Path:
System, Power Sensor Config, More
Remote Command: :SYSTem:PSENsor:CLR
Remote Command Notes: Global to the current mode.
Example: SYST:PSEN:CLR
Mode: MRECEIVE
Key Path:
System, Power Sensor Config, Cal Factor
Remote Command: :SYSTem:CFACtor:DALL
Key Path:
Mode Setup, Calibration, Power Sensor, Cal Factor Edit
Notes: There will be a pop up message to ask user to confirm deletion by pressing
this key again.
Example: :SYSTem:CFAC:DALL
Mode: MRECEIVE
Key Path:
System, Power Sensor Config, Cal Factors, Cal Factor Edit
Preset: 0.0
State Saved: Saved in instrument state.
Min: 0.0
Max: 100.0
To Next Page
Loading...
Need help?
General
