Chapter 2 127
Front-Panel Key Reference
Meas Setup
Key Access: Meas Setup, More, Limits,
Limit 1 or Limit 2
Test
On Off
Turns the testing of the limit lines on
and off. If the trace is at or within the
bounds of the set limit or margin, PASS
LIMIT # or PASS MARGIN # is displayed
in green in the upper left corner of the
measurement area where # is the
number of the selected limit line. Only
positive margins are allowed for lower
limits and only negative margins are
allowed for upper limits. If the trace is
out of the limit or margin boundaries,
FAIL LIMIT # or FAIL MARGIN # is
displayed in red. The results for Limit 2
are displayed below those for Limit 1.
Either
Limit or Margin must be turned
on for Test to work.
Key Access:
Meas Setup, More, Limits,
Limit 1 or Limit 2
Margin
On Off
Margin (Off) turns the margin off.
Margin (On) allows you to set a limit line
offset for the selected limit line. Either
Limit or Margin as well as Test, must be
turned on for a limit test to work.
Key Access:
Meas Setup More, Limits,
Limit 1 or Limit 2
Edit
Accesses the Edit menu keys which
include Point, Frequency (or Time if
XAxis Units (Time) has been selected),
Amplitude, Connected to Previous Pt, and
Delete Point. Edit also accesses the
limits table. The Tab keys allow you to
move between the rows in the limits
table. New limit segments will only be
applied after the editor is closed.
Pressing
Return, or any key not
associated with the editor, will close the
editor.
Key Access:
Meas Setup, More, Limits,
Limit 1 or Limit 2
To Next Page
Loading...
Need help?
General
