6-2 Service Guide E8364-90026
Replaceable Parts PNA Series Microwave Network Analyzers
Information in This Chapter E8362B, E8363B, E8364B
Information in This Chapter
This chapter:
• identifies the replaceable parts for the Agilent PNA series microwave network
analyzers.
• includes several tables and illustrations to assist you in identifying the correct part for
your analyzer.
• contains ordering information for new assemblies and rebuilt-exchange assemblies.
How to Use the Replaceable Parts Listings in This Chapter
There are multiple replaceable parts listings in this chapter for top and bottom assemblies
and top and bottom cables. When searching for the part number for a specific item, it is
necessary to use both the “No Options” listing and the “Options” listing that applies to your
analyzer.
For example: If your analyzer has option UNL installed, and you need the part number for
a replaceable assembly on the bottom of the analyzer, you would refer to both “Bottom
Assemblies, No Options” on page 6-20 and “Bottom Assemblies, Option UNL”
on page 6-24. If the same part is listed in both lists, part numbers listed in the “Options”
listing supersede those in the “No Options” listing.
Chapter Six at-a-Glance
Section Title Summary of Content Start Page
Ordering Information
How to order a replaceable part from Agilent
Technologies.
Page 6-3
Assembly Replacement
Sequence
The correct sequence for replacing a defective
assembly.
Page 6-4
Rebuilt-Exchange Assemblies
The definition of a rebuilt-exchange assembly.
The procedure for replacing and returning a
defective assembly to Agilent Technologies.
Page 6-5
Replaceable Parts Listings
This section lists the assemblies by their
reference number and illustrates the location of
the replaceable parts in the analyzer, including:
• Assemblies (front panel, top, and bottom)
• Cables (top and bottom)
• Options (parts included with options)
• Hardware (internal, hard disk drive, rear
panel, and external)
Page 6-6
To Next Page
Loading...
Need help?
General
