Utility Settings 19
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide 297
To display the user calibration status
Pressing [Utility] > Service > User Cal Status displays the summary results of
the previous User Cal, and the status of probe calibrations for probes that
can be calibrated. Note that passive probes do not need to be calibrated,
but InfiniiMax probes can be calibrated. For more information about
calibrating probes see "To calibrate a probe" on page 68.
Results:
User Cal date:
Change in temperature since last User Cal:
Failure:
Comments:
Probe Cal Status:
To clean the oscilloscope
1 Remove power from the instrument.
2 Clean the external surfaces of the oscilloscope with a soft cloth
dampened with a mixture of mild detergent and water.
3 Make sure that the instrument is completely dry before reconnecting it
to a power source.
To check warranty and extended services status
To learn the warranty status of your oscilloscope:
1 Point your web browser to: "www.agilent.com/find/warrantystatus"
2 Enter your product's model number and serial number. The system will
search for the warranty status of your product and display the results.
If the system cannot find your product's warranty status, select Contact
Us and speak with an Agilent Technologies representative.
To contact Agilent
Information on contacting Agilent Technologies can be found at:
"www.agilent.com/find/contactus"
To Next Page
Loading...
Need help?
General
