2 Agilent N5161A/62A/81A/82A/83A MXG Signal Generators Installation Guide
Safety Information
Instrument Markings
Instrument Markings
The signal generator has the following markings. Familiarize yourself with each marking and its meaning before
operating the signal generator.
The instruction manual symbol. The product is marked with this symbol when it is necessary for
you to refer to instructions in the manual.
The CE mark is a registered trademark of the European Community. If this symbol is
accompanied by a year, it is the year when the design was proven.
The CSA mark is a registered trademark of the Canadian Standards Association International.
The C-Tick Mark is a trademark registered to the Australian Spectrum Management Agency.
This indicates compliance with all Australian EMC regulatory information.
This is the symbol of an Industrial Scientific and Medical Group 1 Class A Product. (CISPER
11, Clause 4)
This symbol marks the on position of the power line switch.
This symbol marks the standby position of the power line switch.
This symbol indicates that the input power required is AC.
This symbol indicates conformance to the standard specifications
a
.
a.LXI Class B Compliance testing using IEEE 1588-2008 not available at release.
ICES/NMB-001
This is a marking to indicate product compliance with the Canadian Interference-Causing
Equipment Standard (ICES-001)
This equipment is Class A suitable for professional use and is for use in electromagnetic
environments outside of the home.
This symbol indicates separate collection for electrical and electronic equipment, mandated
under EU law as of August 13, 2005. All electric and electronic equipment are required to be
separated from normal waste for disposal (Reference WEEE Directive, 2002/96/EC).
To Next Page
Loading...
Need help?
General
