Operating the Power Supply Remotely 4
Series N5700 User’s Guide 57
4 Enable the LAN and, optionally, the built-in Web server using the
applicable check boxes.
5 Click the Set button to save all the settings information.
6 Connect the LAN cable to your instrument and computer. Reboot
the instrument. Wait for the instrument to configure the new
LAN settings.
7 View the LAN settings by clicking the LAN Status tab. Click the
Refresh button to update the display with the assigned IP
Address and Subnet Mask.
8 You can view information about the GPIB or USB interface by
clicking the Connections tab.
You can also use the Setup utility to view model-specific information
about your power supply. Click the Model About tab to view the
model number, serial number, active firmware version, backup
firmware version, and output ratings.
To Next Page
Loading...
Need help?
General
