5 Error Messages
146 N9342C/43C/44C User’s Guide
–144 Character data too
long
Indicates the character data contained
more than 12 characters. (see IEEE
488.2, 7.7.1.4)
764 Unable to save
file
Indicates a failure occurred while saving
a file. The file was not saved.
762 Unable to load
file
Indicates a failure occurred while load-
ing a file. The file was not loaded.
612 File NOT found
Indicates the analyzer could not find the
specified file.
173 Lame package,
please upgrade
firmware
Indicates the current firmware is not
mostly updated. The firmware needs
upgrading.
172 Option install
fail, invalid
option licence
Indicates the option could not be
installed, because of the invalid option
licence.
171 File loaded
Indicates the file loading succeeded.
170 The menu is
unavailable in
this case
Indicates the memo is invalid in this
case.
166 Marker counter
opened in fast
sweep
Indicates the counter’s accuracy
decreases when in fast sweep mode.
162 Cannot open fast
sweep in this case
Indicates current settings do not allow
you to open fast sweep. For example,
currently in FFT, zero span, or any mea-
surement in power suite does not allow
fast sweep.
156 Incorrect
alignment file on
flash
Indicates an invalid alignment file.
153 RF EEPROM operate
fail
Indicates an error when writing align-
ment file.
152 Alignment file
oversize
Indicates the alignment file has error or
invalid data.
151 DSP boot fail
Indicates the analyzer cannot process
measurement currently, wait the
analyzer to reboot. If analyzer froze, try
to restart the analyzer.
Error
Code
Error Message Description
To Next Page
Loading...
Need help?
General
