2 Getting Started
14 N9342C/43C/44C User’s Guide
WARNING
Danger of explosion if the battery is incorrectly replaced.
Replace only with the same type battery recommended.
Do NOT dispose of batteries in a fire.
Do NOT place batteries in the trash. Batteries must be
recycled or disposed of properly.
CAU-CAUTION
Recharge the battery only in the analyzer. If left unused, a
fully charged battery will discharge itself over time.
Temperature extremes will affect the ability of the battery
to charge. Allow the battery to cool down or warm up as
necessary before use or charging.
Storing a battery in extreme hot or cold temperatures will
reduce the capacity and lifetime of a battery. Battery
storage is recommended at a temperature of less than
25
o
C.
Never use a damaged or worn-out adapter or battery.
Charging the batteries internally, even while the analyzer
is powered off, the analyzer may keep warm. To avoid
overheating, always disconnect the analyzer from the AC
adapter before storing the analyzer into the soft carrying
case.
CAU-CAUTION
Connect the automotive adapter to the power output
connector for IT equipment, when charging the battery on
your automotive.
CAU-CAUTION
The VxWorks operating system requires full conformity to
USB 1.1 or USB 2.0 standards from a USB disk. Not all the
USB disk are built that way. If you have problems
connecting a particular USB disk, please reboot the
analyzer before inserting another USB stick.
CAU-CAUTION
The analyzer cannot be used in the standard soft carrying
case for more than 1 hours if the ambient temperature is
higher than 35
o
C.
To Next Page
Loading...
Need help?
General
