Agria 5300 - Gearbox & Wheel Maintenance

5
Maintenance and Repair
42
Meadow mower agria 5300
Machine
Worm gear
Check gearbox oil level
• Check the Gearbox oil level
before each
startup and after every 25 operating hours.
•
Put the machine on level ground (Fig. V)
and unscrew the screw plug (1) or (A/14).
•
The oil level must be level with the filling
opening. Top up gearbox oil if necessary.
• Screw in and tighten the screw plug.
Allow the gearbox to cool
down before you start mainte-
nance work. The temperature
during maintenance should
not be higher than 51° C.
Changing the gearbox oil
Change the gearbox oil once a year, and wh
en
it is still at operating temperature.
•
Clean oil filler plug (A/14) and gearbox cover
(A/15) and their environment to prevent dirt
from getting into the gearbox.
•
To drain the oil, remove gearbox cover (3) or
A/15 from the gearbox housing (unscrew
two hexagon socket screws).
•
Collect the used oil in a suitable container,
and dispose of it properly.
•
Check the seal (2), replace it if necessary,
clean the sealing surfaces, and reinstall the
gearbox cover.
•
Put the machine on level ground and un-
screw the screw plug (1).
•
Fill in fresh gearbox oil until the oil is level
with the filling hole. (Fig. V).
•
Oil filing volume and quality see "Technical
data".
•
Screw in and tighten the screw plug.