AGV Tourmodular User Manual

16 17
IT
FR
DE
ES
PT
РУ
中文中文
EN
10.2 INSTALLATION
Prerequisite: in a seated position, place the helmet upside-down on your knees. Release the fastening
system. Lift the chin guard and sun visor. Begin the operation on the right side cheek pad.
• Attach the cheek pad to the helmet by inserting the plastic strip
7
though its guide
underneath the base trim.
The guide fixing the cheek pad plastic strip guide is interrupted by a screw
8
.
Be sure to continue inserting the plastic strip beyond this interruption.
• Place the plastic ring
5
so that it encircles the snap button
6
located on the front-bot-
tom part of the shell.
• Insert the fastening system
3
through the special opening
4
in the cheek pad.
• Bend cheek pad and lay it to the polystyrene shell, attaching the four snap buttons
1
.
›
›
Repeat the previous operations on the left side.
Repeat the previous operations on the left side.
1
3
2
65
4
1
1 6
5
11
10 CHEEK PADS
10 CHEEK PADS
10.1 REMOVAL
10.1 REMOVAL
Prerequisite: in a seated position, place the helmet up-
Prerequisite: in a seated position, place the helmet up-
side-down on your knees. Release the fastening system.
side-down on your knees. Release the fastening system.
Lift the chin guard and sun visor. Begin the operation on
Lift the chin guard and sun visor. Begin the operation on
the right side cheek pad.
the right side cheek pad.
•
•
Insert your hand inside the helmet between
Insert your hand inside the helmet between
the cheek pad and the polystyrene shell, then
the cheek pad and the polystyrene shell, then
unhook the four snap buttons
unhook the four snap buttons
1
, releasing
, releasing
the cheek pad from the polystyrene shell.
the cheek pad from the polystyrene shell.
•
•
Bend
Bend
the cheek pad
the cheek pad
2
towards the inside of
towards the inside of
the helmet, then remove the fastening sys-
the helmet, then remove the fastening sys-
tem
tem
3
through its appropriate gap
through its appropriate gap
4
(don't
(don't
release the retention system snap button).
release the retention system snap button).
•
•
Free the plastic ring
Free the plastic ring
5
from the snap button
from the snap button
6
located on the lower corner of the shell.
located on the lower corner of the shell.
•
•
Pull out the whole cheek pad by slipping the
Pull out the whole cheek pad by slipping the
plastic band
plastic band
7
from its guide.
from its guide.
›
›
Repeat the previous operations on the left
Repeat the previous operations on the left
side cheek pad.
side cheek pad.
8
7

AGV Tourmodular Specifications

General

Safety Standard	ECE 22.05
Type	Modular Helmet
Shell Material	Carbon-Aramid-Fiberglass
Interior	Removable and Washable
Visor	Pinlock Ready
Weight	1620 g in first shell size
Sun Visor	Integrated
Retention System	Micrometric Retention System
Communication System	Ready for AGV communication system
Ventilation	Adjustable air vents (5 front, 1 rear)