AGV Tourmodular User Manual

18 19
IT
FR
DE
ES
PT
РУ
中文中文
EN
1A
1A
12 WIND PROTECTION
12.1 INSTALLATION AND REMOVAL
Prerequisite: in a seated position, rest the helmet on your knees with the chin guard lowered.
› To install the wind guard, lift the base trim of the chin guard with your fingers and align
the two holes
1
drilled in the plastic strip with the two hooks
2
below the base trim.
› To remove the wind guard, lift the bottom edge of the chin guard with your fingers and pull
the wind guard towards the inside of the helmet, so that the two holes
1
drilled in the
plastic strip are released from the two hooks
2
located below the bottom edge
13 NOSE GUARD
13 NOSE GUARD
13.1 INSTALLATION AND REMOVAL
13.1 INSTALLATION AND REMOVAL
Prerequisite: in a seated position, rest the helmet on your knees. Chin guard closed, visor raised.
Prerequisite: in a seated position, rest the helmet on your knees. Chin guard closed, visor raised.
›
›
Place the nose guard in position, first inserting the central clip
Place the nose guard in position, first inserting the central clip
1
, then the two side ones
, then the two side ones
2
.
.
›
›
To remove the nose guard, first detach the side clips
To remove the nose guard, first detach the side clips
2
individually, then the middle clip
individually, then the middle clip
1
.
.
11 CROWN PAD
11.1 REMOVAL
Prerequisite: in a seated position, place the helmet upside-down on your knees. Lift the chin guard and lock it.
• Release the two snap buttons 1A by detaching them from the neck area 1B.
• Release the two cheek pads upper snap buttons 2A, to release the fabric headset ring 2B.
› Release the five front plastic clips of the headset 3A from their seats 3B located in the
front area of the polystyrene shell.
11.2 INSTALLATION
11.2 INSTALLATION
Prerequisite: in a seated position, place the helmet upside-down on your knees. Lift the chin guard and lock it.
•
•
Place the crown pad inside the helmet with the snap buttons positioned at the back.
Place the crown pad inside the helmet with the snap buttons positioned at the back.
•
•
Snap the two rear snap buttons
Snap the two rear snap buttons
1A
1A
located in the neck area
located in the neck area
1B
1B
.
.
•
•
Attach the two upper snap buttons of the pad
Attach the two upper snap buttons of the pad
2A
2A
, interposing the crown pad fabric rings
, interposing the crown pad fabric rings
2B
2B
.
.
›
›
Attach the five front plastic clips of the headset
Attach the five front plastic clips of the headset
3A
3A
to their seats
to their seats
3B
3B
.
.
3A
3A
3A
3A
3A
3A
3A
3A
3A
3A
1A
1A
1B
1B
1B
1B
2B
2B
2A
2A
2B
2B
3B
3B
3B
3B
3B
3B
3B
3B
3B
3B
1
1
2
2
1 22

AGV Tourmodular Specifications

General

Safety Standard	ECE 22.05
Type	Modular Helmet
Shell Material	Carbon-Aramid-Fiberglass
Interior	Removable and Washable
Visor	Pinlock Ready
Weight	1620 g in first shell size
Sun Visor	Integrated
Retention System	Micrometric Retention System
Communication System	Ready for AGV communication system
Ventilation	Adjustable air vents (5 front, 1 rear)