Screens & Keypad Parameters:
Click on Parameters
Click on Screens & Keypad
A) Backlight Activation, brightens the
display screen between the start and end
times set. When installed in a bright area,
you may want to adjust the time so that it is
off during daylight hours.
B) Scroll Display Speed, adjusts the
scrolling speed when using the arrow keys
to scroll through the names.
C) Checking the Resident
alphanumerical quick-find box, allows
the number buttons to be used to “jump”
alphabetically. 2=A, 3=D, 4=G, 5=J, 6=M,
7=P, 8=T, 9=W. Enabling this requires that
the “#” key is entered prior to any keypad
entry code.
Checking the Speed dialing box enables
the speed dial feature, allowing visitors to
dial tenants by either their apartment
number or personal number.
Checking the Direct dialing via* box
allows a visitor to dial a tenant by pressing
the * followed by the tenant’s phone
number.
D) Screen Resets allows you to adjust the
time before the screen resets back to the
default screen. (min 2, max 10 sec)
Messages:
Click on Parameters
Click on Messages
A
B
C
D
A) Message 1-9, are voice announcements heard
at the door panel. Checking the On box will allow
that message to be accessed.
B) Message 4, corresponds to the activation of
Relay 1 and 2. It can either be a voice message, a
single beep, or a beep for the duration of the relay
contact.
C) Message 10 has 3 options: Off, On, and
Response Off. On allows the message “Call from
Door Panel” to be heard at the phone receiving the
call and at the panel. Response Off only plays the
message at the phone, not at the panel.
D) Message Volume on Speaker controls the
volume heard at the panel. Beep Volume controls
the volume of any beeps heard at the panel.
Message Volume on Line controls the volume
heard by the phone. Checking the Keypad Button
Beeps box allows the panel to emit a beep every
time a button is pressed.
B
C
D
A
Pg. 12
To Next Page
Loading...
