Period Types:
Period Types allow you to change the access parameters based on a time schedule. The TL-2000 has 5 different periods
that can be scheduled, Group A, B, C, D, and Door Panel. A period type is a 7 day week schedule, with 1 time zone, 2 time
zones, or a combination of both. To start, click on Period Types from the Parameters tab.
Click on Parameters
Click on Period Types
A
B
C
E
F
G
H
I
A) Group A, B, C, D, allows you to select
up to four different groups, with each group
having its own parameters for door entry
controls.
B) Door Panel, allows you to determine
what occurs at the door panel during the
different periods. (see next page)
C) Keypad Codes, opens a 2
nd
window
that allows you to enter 4 different codes
for the specified period. When the codes
are entered during the specified period,
Relay 1 will be activated.
D) Name, allows you to name the specific
periods.
E) Calls Inside of Periods 1 and 2, will
determine what the panel does during the
specified periods when the bell button is
pressed after locating a tenant. Calls will
allow the panel to call a tenant. Activates
Relay 1 will activate relay 1 instead of
calling the tenant. Activates Relay 2 will
activate relay 2 instead of calling the
tenant. Activates Relays 1 and 2 will
activate relays 1 and 2. Activates
Relay(s) of Resident will activate the relay
associated with the tenant. Security
Delay triggers the associated relay after a
specified timeframe to give the impression
that the entrance was monitored before
giving access to building. (max 60 sec)
F) Call Outside of Periods 1 and 2, will
determine what the panel does outside of
the specified period. Calls will allow the
panel to call the tenant. Plays Message 2
will play pre-recorded message 2 rather
than call the tenant. The default message
2 is “Your correspondent cannot be
reached at this time, please try again
later”. Calls Caretaker calls the pre-
assigned number rather than the tenant.
G) Bank Holidays will refer to isolated
dates that should ignore the specified
periods. Enter the month and day
numerically.
H, Period 1, Period 2. Enter the hour and
minute for each day for the start and end of
the specified period. Put time in the 24
hour format. If all times are the same as
Monday, simply click on the Copy Monday
button to auto-populate the remaining
days.
I) Holidays, allows you to enter a start
date and end date if sequential days need
to ignore the specified periods. Enter as
month/day/year.
D
Pg. 10
To Next Page
Loading...
