Default Parameters
Relay No. 1 activated by:
Telephone handset code 0
Operation time (sec) 5
Relay No. 2 activated by:
Telephone handset code 2
Keypad on panel code 4444
Operational time (sec) 5
Operational mode Controlled access – 24 hrs
Managing Agent keypad code Off
Installation Company keypad code Off
Communication time (sec) 60
Handset rings for (sec) 25
Panel rings for (sec) 6
Incorrect keypad entries prior to lockout Unlimited
Keypad lockout for Off
Door “Free Access” times Off
Audio messages On
Ring tones OP settings
Busy tones OP settings
Default Messages
Message 1: “Please wait, your call is in progress”
Message 2: “Your correspondent cannot be reached at this time. Please try again.”
Message 3: “You have dialed incorrectly.”
Message 4: “Please enter.”
Message 5: “Sorry, the line is busy. Please try again later.”
Message 6: “Sorry, no answer. Please try again later.”
Message 7: “The code entered is incorrect.”
Message 8: “The code entered is correct.”
Message 9: “Please dial your correspondent’s telephone number.”
Message 10: “Call from door panel.”
Message 1-9 must be in the format wav, A-law, mono, 8000Hz. Message 10 must be in wav, linear 8 bits, mono, 8000Hz.
To Next Page
Loading...
