Maintenance
The equipment contains live electrical and moving parts, ISOLATE prior to maintenance or repair work.
GENERAL MAINTENANCE
The maintenance schedule indicates the time period between maintenance operations.
3 MONTHS
At every service visit the following checks should be carried out:
Fan & Motor Assembly
1 Examine the fan and motor assemblies for lateral and end play in the bearings.
2 Ensure that no water is entering the motor via the electrical gland plate.
3 Check fan blades for damage and corrosion.
Refrigeration Circuits
1 Visually examine pipework and components for damage, wear and tear and oil patches, the latter being
indicative of a system leak.
2 Ensure the fan head pressure controller is controlling the head pressure at the required setting as indicated on
the commissioning sheets provided.
The gauges can then be removed from the system. Do not forget to replace the security caps on the Schrader valves.
Condenser Coil
Clean the condenser coil with a sti bristled hand brush. If dirt has accumulated over a long period or the coil is greasy
or sticky, then it may be necessary to use a water hose or chemical pressure hose. Take care not to damage the ns
and comb out if they have become damaged in any way. For epoxy coated coils use a suitable cleaning uid and soft
bristle brush.
Electrical
1 Check all electrical connections for signs of overheating or arcing.
2 Check all cables for signs of chang or physical damage.
Cabinet
1 Clean the cabinets using a mild detergent.
2 Treat any paint damage or rust as necessary.
12 MONTHS
As per 3 months plus the following:
1 Check all electrical connections for security.
2 Check all refrigeration connections with a leak detector.
ALL work MUST be carried out by technically trained competent personnel.
Do not use steam for cleaning condenser coils otherwise damage or danger may result from
excessive internal pressures.
Ensure relevant F-Gas Regulation checks are carried out at the appropriate period.
CR12 - CR165 50/60Hz CONDENSERS
34 Condenser Technical Manual 6666879 V2_02_2020
Technical