AIRLESSCO SP200 - Technical Data

Technical Data
3A0994E 31
Technical Data
SP200, Mustang 2400
Electrical Power Requirements . . . . . . . . . . . . . . . . . . . 120 Vac, 60 Hz, 15A, 1 phase
Working Pressure Range. . . . . . . . . . . . . . . . . . . . . . . . 0 - 2800 psi (0-19 MPa, 0-193 bar)
Generator required . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1500W minimum
Electric Motor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9.0A (open frame, universal)
Operating horsepower . . . . . . . . . . . . . . . . . . . . . . . . . . 1/2
Power Cord . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 AWG, 3-wire, 6 ft (1.8m)
Fluid inlet fitting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3/4 in. internal thread (standard garden hose thread)
Fluid outlet fitting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1/4 NPSM external thread
Inlet screen (on suction tube) . . . . . . . . . . . . . . . . . . . . 35 mesh (450 micron)
Maximum Delivery (with tip). . . . . . . . . . . . . . . . . . . . . . 0.24 gpm (0.91 lpm)
Paint Hose . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1/4 in. x 25 ft. (6.4 mm x 7.5 m)
Maximum tip hole size . . . . . . . . . . . . . . . . . . . . . . . . . . 0.015 in. (0.38 mm)
Weight, sprayer only . . . . . . . . . . . . . . . . . . . . . . . . . . . 13.3 lb (6.0 kg)
Weight, sprayer, hose and gun . . . . . . . . . . . . . . . . . . . 16.5 lb (7.5 kg)
Dimensions: Upright
Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14.5 in. (36.8 cm)
Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12.4 in. (31.5 cm)
Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17.9 in. (45.5 cm)
Wetted Parts, pump and hose . . . . . . . . . . . . . . . . . . . . stainless steel, brass, leather, ultra-high molecular
weight polyethylene (UHMWPE), carbide, nylon, alumi-
num, PVC, polypropylene, fluroelastomer
Wetted Parts, gun . . . . . . . . . . . . . . . . . . . . . . . . . . . . . aluminum, brass, carbide, nylon, plated steel, stainless
steel, UHMWPE, zinc
Storage Temperature Range
◆❖ . . . . . . . . . . . . . . . . . . -30°F - 160°F (-35°C - 71°C)
Operating Temperature Range ✔. . . . . . . . . . . . . . . . . . 40°F - 115°F (4°C - 46°C)
◆ When pump is stored with non-freezing fluid. Pump damage will occur if water or latex paint freezes in pump.
❖ Damage to plastic parts may result if impact occurs in low temperature conditions.
✔ Changes in paint viscosity at very low or very high temperatures can affect sprayer performance.