Airoptic GasEye - Page 34

Installation
34
GasEye Cross Duct SG and MG
Operat
ing instructions,
0
5
/202
1
3. Remove the fine aligning
piece from the aiming
tool. Loosen the screw
on the side of the aiming
tool and slide the fine
aligning piece out.
Figure 25. Fine aligning piece.
4. Position the aiming
piece base on the flange
and ensure that the
screw on the side of the
aiming tool is in line with
the purging inlet (on the
side of the flange).
Figure 26. Aiming piece positioning.