38
(
657238
)
Commissioning notes
IMPORTANT: It’s strongly recommended NOT to use the Panasonic wall controller
and the gateway at the same time. It may damage the indoor PCB in long term
and in extreme weather conditions.
1. Wire AirTouch, gateway and AC indoor as per diagram and leave the
dipswitches on the gateway at their default position. Make sure all wires are
connected properly. If the gateway address is not 1, follow the Gateway
Address Setting table to set the address.
2. Initialise the AC Unit with Panasonic AC Wall Controller connected to do the
required eld settings. The Panasonic wall controller can be wired to R1 and R2
in parallel with the gateway.
3. Remove the Panasonic wall controller after commissioning.
4. If AirTouch sensors are to be used for AC temperature control, go to AirTouch
AC setting and select the proper sensor.
Wiring Diagrams contd.
To Next Page
Loading...