~
TRANSMITTER SIDE VIEW
( 1)
1. Back (Speed control brake} switch.
2. Throttle Trigger.
3. Carrying Handl
e.
•
J+>"t+-
(21
+-++--(3)
TRANSMITTER BATTERY INSTALLATION
The transmitter batteries are located in the pistol grip handle.
To
install
or
replace, first open the bottom cover. Press down on
the end marked
"OPEN," and slide cover in the direction of the
arrow.
The battery holder will now drop out.
Install eight Alkaline
Type
"M'
dry cells as shown. Observe the polarity (positive and
negative) markings on the cells and on the sides
of
the battery
holder. Notice that the contact springs inside the holder always
go
to
the cell negative end.
Install the battery holder back in the handle; the slant
ed
ends
should match and
th
e end of the battery holder with the two con-
tacts goes in first. Replace the compartment cover.
An Airtronics rechargeable
Ni·Cd battery pack is also available.
It is installed in the same manner, except that the wire harness
from the battery must be plugged into a socket locat
ed
under
the compartment cover. Charging is through the socket under
the switch.
To Next Page
Loading...
