OPERATING INSTRUCTIONS
9
Insert film roll
Please rotate the spindle anti-clockwise
(about 1/2 turn) to unlock the core holder.
To load and also to unload a film roll.
Turn clockwise to lock.
Please note that the roll sits all the way on
Load the roll of film onto the unlock film roll
shaft.
Please note the side of air fill channel of the film.
The channel must be on the side closest to the
machine.
Guide the air fill channel of the film onto the air
nozzle. Slide the film on the air nozzle a few more
cm forward in direction of sealing unit.
That will simplify the next step.
Pull the film above the air nozzle and through the
film channel and press the “IN/OUT button”
while pulling the film all the way through.
The corner of the film can be cut at an angle to
make it easier to fit the film over the air nozzle.
To Next Page
Loading...