Akai 42” - Basic Operation; Power ON;OFF; Selection of Input Mode

19
When select the input source, the screen will
display the information of selected input source.
59
Mono
AV No signal
When there is no signal from the selected source, the
warning message will be displayed
as per illustration.
Either change the channel in TV mode or press the
Source button to change source.
DTV → TV → AV → S-Video → YPbPr 1→ YPbPr 2 →VGA → HDMI1→ HDMI2
6. Basic Operation
6.1 Power ON/OFF: The Display
is in Standby mode
- Press Standby ( ) button on the remote
control or on the side panel to turn on the unit.
The power indicator changes from red to
green.
- Press Standby (
) button on the remote
control or on the side
panel again to return
the display to standby mode. The power
indicator changes from green to red.
Source
Standby
6.2 Selection of Input Mode
- Press the Source button to select the signal source you desired. The signal
sources are displayed in the following sequence: