18
Connect to antenna
ATSC (DTV) & NTSC(ATV) input connection config
1. There are two Antennas:
- ANT 1 is only for ATSC channel of Air or Clear QAM.
- ANT 2 is only for Air or Cable Signal of NTSC.
2. The user can select the Antenna input as below:
A. One Antenna is for signal config.
B. Two Antenna config A
ANT 1 is only for ATSC channel of Air or Clear QAM.
ANT 2 is only for signal of NTSC.
Splitter
ANT 1 (DTV)
ANT 2 (ATV)
ATSC/
Clear QAM
NTSC
ANT 1 (DTV)
ANT 2 (ATV)
Initial Setup Instruction Guide
Connect the power and antenna to your television; then turn on TV . The first time
you use your LCD the initial setup menu will appear on the screen:
Move the cursor as follows:
Press∧ or ∨
to highlight the item
“Language”, and then press
＜ or ＞
to select
“English”, “Français” or
“Español”
.
Press ∧ or ∨
to highlight the item
“Tuner Mode”, and then press
＜ or
＞ to select “ Cable” or “Air”.
Press ∧ or ∨
to select “OK” to start scan, or “Cancel” to exit.
Note: Initial setup is for the Analog TV stations only.
If you would like to end the scanning process, press Enter button to exit. If you
would like to scan for stations again, select “Searching” in the TV menu.
If you select “Cancel” and do not scan in the TV menu, the initial setup menu
will appear again when you turn on TV next time.
To Next Page
Loading...
