Akai 42” - Page 25

25
The “V-Chip” menu includes the “V-Chip Enable”, “Block MPAA Rating”, “Block TV
Rating”, etc. functions. You can use these functions after entering the correct PIN
code.
Entering the PIN code
▪ When the PIN code is already stored:
Press the Number buttons (0~9) to enter the
4-digit PIN code used for blocking channels,
and then press the Enter button.
Note: The initial password for the system is “0000”.
If you have forgotten the password, please contact your local service centre.
You can press the Enter button to display “Input Your Password Please” menu
again, then entering the PIN code, or press ∨ , ∧ , ＜ or ＞ button to move
cursor to “Cancel” and press the Enter button to close up this menu.
If the input is invalid, a message will pop up as below;
 󱯒
Use 0~9 buttons input the
password, then Press the Enter.
The V-Chip pop up menu will
automatically appear after you
press enter.
󱯔 Use 0~9 buttons input your new password.
󱯖 Press ∨ button to move to confirm blank.
󱯘
Use 0~9 buttons input your new password again.
󱯚 Press the Enter button to confirm .
Note: Please be sure to change the password the first time you operate the V-Chip
feature.
Using the “Change Password” item
 󱯎 After entering the “V-Chip” menu, press ∧ or ∨ button to highlight the
“Change Password” item.
󱯐Press the Enter button to confrim.