Akai AP-D210/C

fm
=
a
La
@
=
CONTROLS
45 rpm Adapter Holder
Hinge
Spindle
Rubber Mat
Platter
oo DD servo
bs SPEED Selector
SERVO LOCK Indicator
* AP-D210/C’s Head Shell cannot be removed.
L TYPE TURNTABLE
* L type turntables are not equipped with dust cover or hinges.
Dust cover and hinges are not necessary when placing an L
type turntable inside an audio rack with a special section for a
turntable.
Groove for Overhang Adjustment
J. OE]
CUT/RETURN Switch
-— Auto-return Adjustment Screw
-— Tone Arm Lifter
Hinge
Main Weight
Stylus Pressure Scale Ring
Marker
ANTISKATING Adjuster
Tone Arm Lifter Height
Adjustment Screw
Tone Arm Rest and Clamp
Tone Arm
Cartridge Re-setting Screws
Head Shell
Cartridge (AP-D210C only)
——-Cueing (CUE) Lever
(¥ to lift, ¥ to lower)
* Set this lever to the ¥
(lower) position when locking
the Tone Arm to the Tone Arm
Rest.
TURNTABLE PLACEMENT : re
. Before attempting to use your turntable, read this Manual 6.
carefully and keep for future reference.
. Locate the turntable on a firm, level surface.
. Handie the equipment carefully—avoid subjecting it to
sudden shocks such as a slamming of a door.
. Keep the unit out of the direct sunlight, in a place relative-
ly free of dust and humidity.
5.
Provide
about
10
centimeters
at
the
rear
of
the
unit
to
permit the dust cover to be raised without jarring the
turntable.
& ON
Avoid locating the turntable in the vicinity of other electri-
cal equipment such as television receivers. These gener-
ate signals which can cause humor noise.
. Howling during play is often caused by incorrect speaker
placement. If the speakers are too close to the turntable,
the stylus will pick up vibrations. Avoid placing the unit
On a speaker cabinet.
.
When
interconnecting
the
turntable
and
amplifier,
place
the turntable on the side of the amplifier away from the
amplifier’s transformer, to avoid noise pick-up.