Akai AP-Q310 - Page 36

No. 7
MODEL ap-9310/¢C
3. LEAD-IN/LEAD-OUT ADJUSTMENTS (Fig. 7)
1) Lead-in position
a)
b)
Cc)
dq)
Place a record on the Platter.
Auto-play the record and confirm where the Stylus descends.
Depress the CUT/RETURN switch to return the Tone Arm to the Tone
Arm Rest.
Move the Tone Arm towards the Platter until the Lead-in Adjustment
Screw is visible.
Turn the Lead-in Adjustment Screw with a screwdriver:
Clockwise: To make the Stylus descend towards the Spindle.
Counterclockwise: To make the Stylus descend away from the Spindle.
2) Lead-out position
a)
b)
NOTE:
Auto-play the record and confirm where auto-return begins.
Turn the Lead-out Adjustment Screw with a screwdriver:
* The Lead-out Adjustment Screw is visible without moving the
Tone Arm.
Clockwise: To delay auto-return.
Counterclockwise: To hasten auto~-return.
Carry out both adjustments little at a time and confirm the
position after each adjustment.