Akai AP-Q310 - Page 43

No.
II,
MODEL _pp-941/c
VOLTAGE AND CYCLE CONVERSION
110—120VF1:400mA
220—240V F2: 400mA
FRONT
Fig. 1 Voltage Conversion (U Model only)
VOLTAGE CONVERSION
Models for Canada, USA, Europe, UK, Australia and Japan are not equipped
with this facility.
Each unit is preset at the factory depending on its destination, but some
units can be converted to 110-120V or to 220~240V as required.
If
dee
2s
Sy.
voltage change is necessary, this can be accomplished as follows:
Disconnect the power cord.
Remove the bottom cover.
Remove the existing Line Voltage Fuse and insert the required Line
Voltage Fuse in the proper fuse holder according to the printed
instructions.
CYCLE CONVERSION
With DC servo motor, cycle conversion is not necessary.