Akai EWV2000 User Manual

29
Try playing with these settings. The sound is similar to that of an oboe.
Also, by setting the VIB/BEND and BREATH INTENSITY parame
ters as follows, it is possible to obtain dynamic expression as a function
of the intensity of the breath.
(8) Now press the VIB/BEND button located on the source 1 side
and set the lip sensor parameters.
Ex.:
(9) Next press the source 2 BREATH INTENSITY button and
set the parameters as follows:
Ex.:
When blown strongly, the sound will be loud and bright.
Brightness = BREATH VCF
Loudness = BREATH VCA
Set the BREATH VCF and BREATH VCA values according to tW
passage and phrase to increase the ability for expression.
NOTE: A clicking sound will be produced if the BREATH VCF
and BREATH VCA values are stronger than the VCF-EG
DEPTH and VCA-EG DEPTH values when breath is ap
plied. When creating sounds, try increasing and decreasing
parameter values to find the best point.
This is due to electric signal reasons and is not a problem with
your equipment. Set the parameter values so that this doesn't
happen.
(10) Now press the EFFECT button located on the source 1 side and
see how the effect filter modes change the sound.
Ex.:
FILTER
: o f f
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html

Akai EWV2000 Specifications

General

Brand	Akai
Model	EWV2000
Category	Recording Equipment
Language	English