Akeeyo AKY-V360ST - Rear Camera Mounting (Without Waterproof); Bracket Installation

RearCameraMouting(WithoutWaterproof)
Installation Instructions
<MountingMethod>
1.Determine the installation position of the rear camera, and stick the rear camera
bracket on the rear glass.
※Wipe off the oil and dirt on the sticking surface, and after it is fully dried, stick it firmly on the rear glass with double-sided
tape. In order to improve the adhesion, after the rear camera body is installed, it is recommended to leave it for 24 hours.
Rear Camera
The rear camera bracket comes from the rear
camera body and can be removed by sliding.
Tear off the sticky cloth.
Stick it firmly on the back glass.
2.Mount the rear camera on the bracket.
Hold up the rear camera and slide it to install.
The angle of the rear camera can be
adjusted by rotating.
※Be sure to adjust while supporting
the bracket part.
11