RF Card Code FormatRF Card Code Format
To integrate the RF card door access with the third-party intercom system, you need to match the
RF card code format with the one used by the third-party system.
To set it up, go to Access Control > Card Setting > RFIDAccess Control > Card Setting > RFID interface.
IC Card Display ModeIC Card Display Mode: Set the card number format from the provided options. The
default format in the device is 8HN.
Events Triggered by Using RF CardsEvents Triggered by Using RF Cards
You can set up the events triggered by swiping the RF cards on the Access Control > CardAccess Control > Card
Setting > Setting > RF C ard EventRF Card Event interface.
Action to ExecuteAction to Execute: Set the desired actions that occur when the door is opened by
swiping the RF card.
EmailEmail: Send a message to the preconfigured Email address.
FTPFTP : Send a message to the preconfigured FTP address.
Mifare Card EncryptionMifare Card Encryption
The door phone can encrypt Mifare cards for greater security. When this feature is enabled, it reads
the data in the cards’ designated sectors and blocks, not the UID.
To encrypt the card, navigate to the Access Control > Card Setting > Mifare CardAccess Control > Card Setting > Mifare Card
EncryptionEncryption interface.
To Next Page
Loading...
