Action To ExecuteAction To Execute: Set the desired actions that occur when the specific Input interface is
triggered.
FTP: Send a screenshot to the preconfigured FTP server.
Email: Send a screenshot to the preconfigured Email address.
SIP Call: Call the preset number upon the trigger.
HTTP: When triggered, the HTTP message can be captured and displayed in the
corresponding packets. To utilize this feature, enable the HTTP server and enter
the message content in the designated box below.
HTTP URLHTTP URL: Enter the HTTP message if selecting HTTP as the action to execute. The
format is http://HTTP serverās IP/Message content.
Action DelayAction Delay: Specify how many seconds to delay executing the preconfigured actions.
Action Delay ModeAction Delay Mode:
Unconditional Execution: The action will be carried out when the input is triggered.
Execute If Input Still Triggered: The action will be carried out when the input stays
triggered. For example, if the door stays open after triggering input, an action such
as an email will be sent to notify the receiver.
Execute RelayExecute Relay: Specify the relay to be triggered by the actions.
Door StatusDoor Status: Display the status of the input signal.
Unlock by BluetoothUnlock by Bluetooth
The Bluetooth-enabled SmartPlus app enables users to enter the door hands-free. They can either
open the door with the app in their pockets or wave their phones towards the door phone as they
get closer to the door.
To configure Bluetooth, go to Access Control > BLEAccess Control > BLE interface.
To Next Page
Loading...
