Unlock by Exit ButtonUnlock by Exit Button
When users need to open the door from inside by pressing the Exit button, you need to set up the
Input terminal that matches the Exit button to activate the relay for the door access.
To set it up, navigate to the Access Control > InputAccess Control > Input interface.
EnabledEnabled: To use a specific input interface.
Trigger Electrical LevelTrigger Electrical Level: Set the input interface to trigger at a low or high electrical level.
NoteNote
The HTTP format for relay triggering varies depending on whether the door phone's high
secure mode is enabled. Please refer to this how-to guide Opening the Door via HTTPOpening the Door via HTTP
CommandCommand for more information.
To Next Page
Loading...
