Integration via WiegandIntegration via Wiegand
The device can be integrated with third-party devices via Wiegand.
Set it up on the Access Control > Card Setting > WiegandAccess Control > Card Setting > Wiegand interface.
Wiegand Display ModeWiegand Display Mode: Select the Wiegand card code format from the provided
options.
Wiegand Card Reader ModeWiegand Card Reader Mode: The transmission format should be identical between the
access control terminal and the third-party device. It is automatically configured.
Wiegand Transfer ModeWiegand Transfer Mode:
InputInput: The device serves as a receiver.
OutputOutput: The device serves as a sender. If users can only open the door by swiping
an RF card, select the Wiegand transfer mode as Output.
Convert To Card No. OutputConvert To Card No. Output: The device serves as a sender. If users are
assigned multiple door-opening methods, select the Wiegand transfer mode as
Convert To Card No. Output.
Integration with Third Party DeviceIntegration with Third Party Device
To Next Page
Loading...
